Figure 72 Switch In Access Gateway Mode Without F_Port Masterless Trunking; Figure 73 Switch In Access Gateway Mode With F_Port Masterless Trunking - HP StoreFabric SN6500B Administrator's Manual

22
F_Port trunking
FIGURE 72
FIGURE 73
NOTE
You do not need to map the host to the master port manually, because the Access Gateway will
perform a cold failover to the master port.
See
configuring F_Port trunking.
Requirements for F_Port trunking on an Access Gateway
In addition to the requirements listed in
Access Gateway Administrator's Guide for additional requirements that are specific to F_Port
trunking on an Access Gateway.
Configuring F_Port trunking for an Access Gateway
Access Gateway trunking configuration is mostly on the edge switch. On the Access Gateway
module, you only need to ensure that the trunking license is applied and enabled.
544
Switch in Access Gateway mode without F_Port masterless trunking
Switch in Access Gateway mode with F_Port masterless trunking
"Configuring F_Port trunking for an Access Gateway" on page 544 for instructions on
"Requirements for trunk groups" on page 536, refer to the
Fabric OS Administrator's Guide
53-1002745-02