HP StoreFabric SN6500B Administrator's Manual page 413

This command is used to set up secret keys for the DH-CHAP authentication.
The minimum length of a secret key is 8 characters and maximum 40 characters.
Setting up secret keys does not initiate DH-CHAP authentication. If switch is
configured to do DH-CHAP, it is performed whenever a port or a switch is enabled.
Warning: Please use a secure channel for setting secrets. Using an insecure
channel is not safe and may compromise secrets.
Following inputs should be specified for each entry.
1. WWN for which secret is being set up.
2. Peer secret: The secret of the peer that authenticates to peer.
3. Local secret: The local secret that authenticates peer.
Press enter to start setting up secrets >
Enter peer WWN, Domain, or switch name (Leave blank when done):
10:00:00:05:33:13:70:3e
Enter peer secret:
Re-enter peer secret:
Enter local secret:
Re-enter local secret:
Enter peer WWN, Domain, or switch name (Leave blank when done):
Are you done? (yes, y, no, n): [no] y
Saving data to key store... Done.
myswitch:admin> secauthsecret --show
WWN
-----------------------------------------------
10:00:00:05:33:13:70:3e
Example Enabling encryption on port 1 of 'myswitch'
There are two things to notice here— the first is that the initial attempt fails because the port is
currently enabled. The second is that the output from the second attempt shows encryption to be
enabled on the port, as shown by the portCfgShow command.
myswitch:admin> portcfgencrypt --enable 1
Please disable port to configure Encryption/Compression.
myswitch:admin> portdisable 1
myswitch:admin> portcfgencrypt --enable 1
myswitch:admin> portenable 1
myswitch:admin> portcfgshow 1
Area Number:
Octet Speed Combo:
Speed Level:
AL_PA Offset 13:
Trunk Port
Long Distance
VC Link Init
Locked L_Port
Locked G_Port
Disabled E_Port
Locked E_Port
ISL R_RDY Mode
RSCN Suppressed
Persistent Disable
LOS TOV enable
NPIV capability
Fabric OS Administrator's Guide
53-1002745-02
DId Name
8 sw0
1
1(16G|8G|4G|2G)
AUTO(SW)
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
Working with EX_Ports
14
413