Figure 32 Fabric Incorrectly Configured For Ti Zone With Failover Disabled - HP StoreFabric SN6500B Administrator's Manual

12
Traffic Isolation Zoning overview
•
•
•
•
FIGURE 32
•
348
Ensure that there are multiple paths between switches.
Disabling failover locks the specified route so that only TI zone traffic can use it. Non-TI zone
traffic is excluded from using the dedicated path.
You should enable failover-enabled TI zones before enabling failover-disabled TI zones, to avoid
dropped frames.
When you issue the cfgEnable command to enable the zone configuration, if you have failover
disabled zones, do the following:
1. Temporarily change failover-disabled TI zones to failover-enabled.
2. Enable the zones (cfgEnable).
3. Reset all the zones you changed in
4. Enable the zones again (cfgEnable).
These steps are listed in the procedures in this section.
It is recommended that TI zone definitions and regular zone definitions match.
Domain controller frames can use any path between switches. Disabling failover does not
affect Domain Controller connectivity.
For example, in Figure 32, if failover is disabled, Domain 2 can continue to send domain
controller frames to Domain 3 and 4, even though the path between Domain 1 and Domain 3
is a dedicated path. Domain controller frames include zone updates and name server queries.
= Dedicated Path
= Ports in the TI zone
Fabric incorrectly configured for TI zone with failover disabled
It is recommended that the insistent Domain ID feature be enabled; if a switch changes its
active domain ID, the route is broken. See the configure command in the Fabric OS Command
Reference for information about setting insistent Domain ID.
step 1 to failover-disabled.
Domain 1
8
1
9
3
15
Domain 2
Domain 3
9
12
7
6
5
Domain 4
Fabric OS Administrator's Guide
53-1002745-02