Figure 38 Traffic Isolation Zoning Over Fcr - HP StoreFabric SN6500B Administrator's Manual

FIGURE 38
In addition to setting up TI zones, you must also ensure that the devices are in an LSAN zone so
that they can communicate with each other.
If failover is enabled and the TI path is not available, an alternate path is used. If failover is disabled
and the TI path is not available, then devices are not imported.
NOTE
For TI over FCR, all switches in the backbone fabric and in the edge fabrics must be running
Fabric OS v6.1.0 or later.
Fabric OS Administrator's Guide
53-1002745-02
Edge fabric 1
= Dedicated path set up by TI zone in edge fabric 1
= Dedicated path set up by TI zone in edge fabric 2
= Dedicated path set up by TI zone in backbone fabric
Traffic Isolation Zoning over FCR
Traffic Isolation Zoning over FC routers
Backbone
fabric
12
Edge fabric 2
353