Installation Wizard For Windows Users; Running The Installation Wizard - HP StorageWorks D2D - Backup Systems User Manual

• Create a base configuration to get started (This is not possible if you are configuring only FC
devices on the HP D2D Backup System)
UNIX and Linux users should download the latest patches for their operating system and refer to the
"Linux and UNIX Configuration Guide" on the HP StorageWorks D2D Backup System CD-ROM for
configuration instructions.

Installation wizard for Windows users

For Windows users, the recommended way to set up the HP D2D Backup System network is to run
the Installation wizard from the HP StorageWorks D2D Backup System CD-ROM, particularly if you
are configuring the host for the first time.
The HP D2D Backup System can be used to back up a maximum of 24 hosts. You should run the
Installation wizard on each host that will provide a source of data for backup. The wizard configures
the software components needed to connect from the host and use the HP D2D Backup System. The
host may be a server, workstation or PC.

Running the Installation wizard

NOTE:
You must have the necessary administrative rights on the host to run the Installation wizard successfully
and the host should be connected to the Internet in case it is necessary to download the Microsoft
iSCSI Initiator.
The host server on which you are installing the D2D must be on the same subnet in order for Discovery
to work. If it is on a different subnet, refer to
manually configuring it.
1. Insert the CD-ROM supplied with your HP D2D Backup System into the host machine. It should
launch automatically. If it does not, locate the D2DInstallationWizard.exe file and run it manually.
40 Connecting and installing the HP D2D Backup System
"Advanced installation" on page 53 for instructions on