Shelves; Physical Disks - HP StorageWorks D2D - Backup Systems User Manual

Shelves

This page shows the status of the shelves and the physical disks. You can also use it to beacon a disk
within the HP D2D. The Beacon LED on the front of the individual disk flashes Blue.
Shelves
Click on a shelf (it is highlighted in blue) to display the disks located in that shelf in the Physical Disks
section.
Shelf:
Status:
Configuration State:
Disks:

Physical disks

When you select a shelf, the disks within it are displayed in the Physical Disks section. Use the
information in this section to identify disks that may be failing or disks that are approaching capacity.
You can also use it to beacon a disk within the HP D2D. The Beacon LED on the front of the individual
disk is solid blue.
If you need to replace a disk, it is very important to obtain the serial number and the physical location
of the failed disk from this page before you replace it.
128 The Web Management Interface
This is the shelf number. Shelf 0 is the HP D2D Backup System; Shelf 1 is the
Capacity Upgrade Kit, if installed.
In normal operation, this shows green, OK. If one or more disks fail, it shows
a failed icon and a message. The disk should be replaced as soon as
possible. See "Hard disk replacement" on page 185 for more information
about replacing the disk.
This indicates whether the shelf has been configured. It is shown as not
configured if it is not yet part of the storage pool.
The number of available physical disks in the shelf including the online spare
disk.