HP StorageWorks D2D - Backup Systems User Manual page 105

2. Connect a tape drive or library to the host server.
3.
Install the backup application on the host, then import and recover the data from physical tape.
4. At this point there is no HP D2D Source Appliance at the remote site. If one is installed at a later
date, you can reverse recover the data and configure replication, as described in
"Reverse replication, source lost and mapping
The following procedure may be used if there is a tape library or tape drive attached to the host.
IMPORTANT:
This recovery method is not suitable if the Target Library at the Data Center also has slot mappings
from Source Libraries on other remote sites.
1. On the Target Appliance in the Data Center, go to the Replication - Mapping Configuration page,
select the Target Library and remove the slot mapping between it and the lost Source Library.
2. As long as there is only one slot mapping to the Target Library, it will become a Non-Replicating
Library.
NOTE:
If there are other mappings, do not remove them if it will break other library replication. Do not
proceed, this method is not suitable.
3. Edit the port configuration of the newly promoted Non-Replicating Library to make it iSCSI.
4. Install the iSCSI initiator on the host machine at the remote site where recovery is to occur and
install the backup application.
5.
Configure the iSCSI Initiator Name for the newly promoted Non-Replicating Library to be that of
the host system.
6.
Connect to the Data Center appliance and library via iSCSI from the host at the remote site.
7. Copy the last full backup and any subsequent incrementals to physical tape.
8. Transport the cartridges to the remote office.
9. Connect a tape drive or library to the host server.
10.
Install the backup application on the host, then import and recover the data from physical tape.
11. At this point there is no HP D2D Source Appliance at the remote site. If one is installed at a later
date, you can reverse recover the data and configure replication, as described in
"Reverse replication, source lost and mapping
deleted" on page 97.
deleted" on page 97.
D2D Backup System HP D2D4112 105