Nikon COOLPIX S230 User Manual page 164

n
F,"
I
z
If the camera fails to function as expected, check the list of common problems
below before consulting your retailer or Nikomauthorized service representative.
Refer to the page numbers in the righbmost column for more information.
Display, Settings and Power Supply
Problem Cause/Solution °-_
Monitor is blank. Camera is off. 24
Battery is exhausted. 24
Standby mode for saving power: press the power l g, 25
switch, the shutter-release button, the I_1 button, or
the[_ button.
When flash lamp blinks red, wait until flash hascharged. 33
Camera and computer are connected via USB cable, g4
Camera and TV are connected via AV cable, gl
interval timer photography in progress. 114
Monitor is hard to read. Adjust monitor brightness. 133
Monitor is dirty. Clean monitor. 147
Camera turns offwithout _ Battery is low. 24
warning. _ Camera has turned off automatically to save power. 136 Battery is cold. 146
Date and time of Pictures recorded before clock has been set, and 20
recording are not correct. "Date not set" indicator blinks during shooting, will
have time stamp of %0/00/0000 00:00% movies and
voice recordings will be dated "01/01/2009 00:00." In
list by date mode, pictures are recognized as having
been taken on 01/01/2009. Set the correct time and
date from the Date option in the setup menu.
Check camera clock regularly against more accurate
timepieces and reset as required.
Tap D to change the information displayed in the
monitor.
Camera clock has not been set.
No indicators displayed
in monitor.
Date imprint not
available.
130
12
20,
130
152