Dhcp; Ip Address; Network Standby; Update Notice - Onkyo HT-R758 Instruction Manual

m DHCP
Enable
Disable
This setting determines whether or not the AV receiver
uses DHCP to automatically configure its IP Address,
Subnet Mask, Gateway, and DNS Server settings.
• ff you select "Disable", you must configure the "IP Address",
"Subnet Mask", "Gateway", and "DNS Server" settings
yourself.
m IP Address
Class A:
"10.0.0.0" to "10.255.255.255"
_ Class B:
"172.16.0.0" to "172.31.255.255"
Class C:
"192.168.0.0" to "192.168.255.255"
Enter a static IP address provided by your Intemet Service
Provider (ISP).
Most routers use Class C IP addresses.
m Subnet Mask
Enter the subnet mask address provided by your ISP
(typically 255.255.255.0).
m Gateway
Enter the gateway address provided by your ISP.
m DNS Server
Enter the DNS server address provided by your ISP.
m Proxy URL
To use a Web proxy, enter its URL here.
m Proxy Port
It you're using a Web proxy, enter a proxy port number
here.
m Network Standby
On
Off
This setting enables or disables control over the network.
When enabled, the NET indicator will be dimly-lit while
the AV receiver is in standby mode. Note that the indicator
may not light under certain conditions (_ page 44).
• When set to "On", the power consumption slightly increases in
standby mode.
I Update Notice
Enable
Disable
When this setting is enabled, you will be notified if a
firmware update via network is available.
• Selecting "Never Remind me" on the notification window will
switch this setting to "Disable" (_ page 19).
• For details on the update notification, see "If the "Update New
F/W" window appears." (_ page
19).
Advanced Operations
En-54 V
©©