Using The Audio Settings Of Quick Setup; Tone Control/Speaker Levels; Audyssey; Late Night - Onkyo HT-R758 Instruction Manual

You can change various audio settings from the Quick
Setup (_ page 41).
• These settings are not available ill either of the following cases:
- The "Audio TV Out" setting is set to "On" (_ page 52).
- "HDMI Ctrl (RIHD)" is set to "On" (_ page 52) and you're
listening through your TV speakers.
Tone Control
N Bass
-10 dB to 0 dB to +10 dB in 2 dB steps
You can boost or cut low-frequency sounds output
from the front speakers.
N Treble
-10 dB to 0 dB to +10 dB in 2 dB steps
You can boost or cut high-frequency sounds output
from the front speakers.
You can adjust the bass and treble for the front speakers,
except when Direct or Pure Audio (European and
Australian models) listening mode is selected.
Operating on the AV receiver
1 Press TONE repeatedly to select either "Bass" or
"Treble".
2 Use - and + to adjust.
Speaker Levels
N Subwoofer Level
-15 dB to 0 dB to +12 dB in 1 dB steps
N Center Level
-12 dB to 0 dB to +12 dB in 1 dB steps
You can adjust the volume of each speaker while listening
to an input source.
These temporary adjustments are cancelled when the AV
receiver is set to standby. To save the setting you made
here, go to "Level Cal (Level Calibration)" (_ page 47)
before setting the AV receiver to standby.
• You cannot use these function while the AV receiver is muted.
• These settings cannot be used while a pair of headphones is
connected.
• Speakers that are set to "No" or "None" in "Sp Config (Speaker
Configuration)" (_ page 46) cannot be adjusted.
Audyssey®
N Audyssey
See "Audyssey" in "Source Setup" (_ page 49).
N Dynamic EQ
See "Dynamic EQ" in "Source Setup" (_ page 49).
N Dynamic Volume
See "Dynamic Volume" in "Source Setup" (_ page 49).
• These technologies can be used when all the following conditions
are met:
- Room Correction and Speaker Setup is completed. Note that
"Audyssey" requires the "Audyssey 2EQ Full Calibration"
method.
- Any listening mode other than Direct or Pure Audio (European
and Australian modds) is selected.
- A pair of headphones is not connected.
• The setting is stored individually for each input selector.
Advanced Operations
Late Night
N Late Night
For Dolby Digital and Dolby Digital Plus sources, the
options are:
Off
Low:
Small reduction in dynamic range.
High:
Large reduction in dynamic range.
For Dolby TrueHD sources, the options are:
Auto:
The Late Night function is set to "On" or "Off"
automatically.
}Off
}On
Turn this setting on to reduce the dynamic range of Dolby
Digital material so that you can still hear quiet parts even
when listening at low volume levels--ideal for watching
movies late at night when you don't want to disturb
anyone.
• The effect of the Late Night function depends on the material that
you are playing and the intention of the original sound designer,
and with some material there will be little or no effect when you
select the different options.
• The Late Night function can be used only when the input source
is Dolby Digital, Dolby Digital Plus, or Dolby TrueHD.
• The Late Night function is set to "Off" when the AV receiver is
set to standby. For Dolby TrueHD sources, it will be set to
"Auto".
En-42 V
©©