Using The Sleep Timer; Setting The Display Brightness; Displaying Source Information - Onkyo HT-R758 Instruction Manual

With the sleep timer, you can set the AV receiver to turn
off automatically alter a specified period.
Press RECEIVER once followed by SLEEP
repeatedly to select tile required sleep time.
The sleep time can be set from 90 to 10 minutes in 10
minute steps.
The SLEEP indicator lights on the AV receiver's
display when the sleep timer has been set. The
specified sleep time appears for about 5 seconds, then
the previous display reappears.
• ff you need to cancel the sleep timer, press SLEEP
repeatedly until the SLEEP indicator goes off.
• To check the time remaining until the AV receiver sleeps,
press SLEEP. Note that if you press again on SLEEP as
the time being displayed is 10 minutes or less, the sleep
timer will go off.
You can adjust the brightness of the AV receiver's display.
1
Press RECEIVER once followed by DIMMER
repeatedly to switch between: normal, dim, or
dimmer brightness.
• (North American models) Alternatively, you call use
DIMMER on the AV receiver.
Turning On & Basic Operations
You can display various information about the current
input source as follows.
1
Press RECEIVER once followed by DISPLAY
repeatedly to cycle through tile available
information.
• Alternatively, you can use DISPLAY on the AV receiver.
The following information can be typically displayed.
Input source &
volume*l B[).."i_)'][) .,........"::":::;
Listening mode
Signal format*2
Sampling
frequency*2
"1 When AM or FM radio is used, the band, preset number, and
frequency are displayed.
*2 If the input signal is digital, the signal format is displayed.
Information is displayed for about three seconds, then the
previously displayed information reappears.
En-39
©©