Setting Up Your Remote Control To Operate Your Cable Box - Curtis Mathes CM27020S Owner's Manual

SPECIAL FEATURES
Setting Up Your Remote Control to Operate Your Cable Box
1
Turn off your
cable box.
On your rem0te contr01, press SET.
_1 Tlle remote control has three
"nlodes': "WVi' "VCm," and
Press the CABLEbutton 0n the top right of your remote "CABLE".
control. Press the "CABLE" botton to switch
the remote control to the "Cable"
n]ode.
Make sure you enter both digits
of the code, even if ttle first digit is a
Enter both digits of the cable box code listed below for your "0." (If inore than one code listed,
brand of cable box. try the first one.)
Press POWER.Your cable box should turn on. If your cable
box turns on, your remote control is now !iset upi! correctly.
-41 If your cable box does not turn
on, repeat steps 2, 3, and 4, but try
one of the other codes listed fbr your
particular brand of cable box. (If no
other codes are listed, try each cable
box code, 00 through 35.)
6
Once your remote control is set up, press the CABLEbutton
_ny time yOUwant to use the remote to operate your cable
bOX,
When your remote control is
in the "CABLE" n]ode, the volume
buttons still control your TV_ vol-
onle. Also, the VCR control buttons
(PLAY, P AUSE,etc.) will still operate
your VCR.
Cable Box
Codes
4.3 c.Ap-.1_
FOU}_: SPE(]AI FIATUIRI S