2: Installation; Connecting Vhf And Uhf Antennas; Antennas With 300-Ohm Flat Twin Leads - Curtis Mathes CM27020S Owner's Manual

INSTALLATION
Connecting VHF and UHF Antennas
If yollr antenna has a set of leads that
look like this, see "Antennas with
300-ohm Flat Twin Leads," below.
If yo_r antenna has one lead that looks
like this, see "Antennas with 75-ohm
Round Leads," on page 2.2.
If
you have two antennas, see "Separate
VHF and UHF
Antennas," on page 2.2.
Antennas with 300-ohm Flat Twin Leads
If"you are using an offUair antenna (sllc'h as a roof antenna or "rabbit ears") that has
300-ohm twin flat leads, follow the directions below.
il ¸ (( (
Place the wires from the
twin leads under the
screws on the 300,75ohm
odapto[ (net supplied),
Use a screwdriver to
tighten the screws.
2
Plug the adaptor into the
VHF!UHFterminal on the
bottom of the back panel.
(HiPqrl/ TWO: INSqAIIA'fION 2. 1