Chapter 4: Special Features - Curtis Mathes CM27020S Owner's Manual

SPECIAL FEATURES
Customizing Your Remote Control
Your TV comes ecluit_ped with
a "universal"
remote control. In addition to
controlling the TV] the universal remote can also operate a VCR and a cable box.
Setting Up Your Remote Control to Operate Your VCR
Turn off your VCR.
On your remote control, press SEl.
The remote control has three
"modes": "TV," "VCR", and "Cable"
press the VCR button 0nthetoPrigbtofyour remote c0ntr01. Press the "VCR" buttoi_ to switch the
remote control to the "VCR" mode.
_,9 Make sure you enter both digits
of
the code, even if the first digit is a "0."
Enter both digits Ofthe VCR cede listed on the next page [o[ If more than one code listed, try the
your brand of VCR. first one.
-q If your VCR does not turn on,
repeat steps 2, 3, and 4, but try one
Press the POWERbutten onthe remote ¢ontro!, Your VCR
of the other codes listed for the
should turn on, If YOUr VCRturns on, your remote contro! is brand of your particular VCR.
now set co[rect!y. If no other codes are listed, try each
cocle, O0 through 72.
-, W,ei. yoor remote co..ttol is ii.
the "VCR" mode. the volume buttons
0nee your remote contr0! is set up, press the 1/Cll button still control your TV's volume.
any time You want to use the remote to operate your VCR.
When your remote is in the "TV"
mode, the VCR control buttons
(PLAY,
PAUSE, etc.) will still operate your
VCR.
4. _ (_HAPTIR FOUR: SPI{(IAI FIA'IURIS