Turning On The Power And Projecting Images - Epson EMP-53 User Manual

Turning On the Projector

Turning On the Power and Projecting Images

PROCEDURE
Check that the Power indicator has stopped flashing
1
and is lit orange.
Lit orange
Turn on the power for all equipment connected to the
2
projector.
For a video source, press the [Play] button at the video source to
start playback if necessary.
Press the [Power] button on either the projector's
3
control panel or the remote control to turn on the
power for the projector.
The Power indicator flashes green. After a short period it stops
flashing and lights steadily, and projection starts.
Wait until the Power indicator lights green (it normally takes
about 40 seconds to change).
Changes from flashing to lit green
TIP
• The [Power] button on the projector's control panel and on the
remote control cannot be operated while the Power indicator is
flashing green.
• Depending on the settings, the message "No-Signal." may appear.
See "Setting" - "No-Signal Msg."
• When projection starts, images will initially be projected at the
"High" brightness setting, even when "Brightness Control" in the
configuration menu is set to "Low". Approximately two minutes
after projection starts, the message "Brightness Control: Switched
into "Low" mode." will be displayed and the brightness will return
to the "Low" setting. See "Advanced" - "Brightness Control"
p.53
27
Remote control
Power
Page down Page up
Computer S-Video/Video Color Mode
Menu A/V Mute Freeze
E-Zoom
Enter
Auto ESC
p.50