Adjusting The Sync - Epson EMP-53 User Manual

Adjusting the Image Quality

Adjusting the Sync

If flickering, fuzziness or interference appear in
images that are input from the computer, and this
cannot be fixed using automatic setup, you will
need to adjust the sync manually using the
following procedure.
PROCEDURE
Press the [Menu] button on the remote control, and
1
then select "Sync." from the "Video" menu.
For details on this operation, refer to "Using the Configuration
Menus". p.57
Video Position
Audio Tracking
Setting
Sync .
User's Logo Brightness
Advanced Contrast
About Sharpness
Reset All Color Mode
Input Signal :
Auto Setup
Reset
[ESC]: Return [ ]: Select [ ]: Adjust
Press the [ ] and [ ] buttons to set the sync value to
2
a value that causes the flickering, fuzziness or
interference to disappear from the image.
The sync value increases or decreases each time a button is
pressed.
Adjust
0000
:
: 0
: 0 - +
: 0 +
-
: 0 - +
Select [Normal [Normal ] ]
: Select
: [Computer ]
:
ON OFF
Execute
[Menu]: Exit
Video Position
Audio Tracking
Setting Sync .
User's Logo Brightness
Advanced Contrast
Sharpness
About
Reset All
Color Mode
Input Signal
Auto Setup
Reset
[ESC]: Return [ ]: Select [ ]: Adjust
After making the adjustment, press the [Menu] button
3
to exit the configuration menu.
TIP
• If you adjust the sync without adjusting the tracking first, it will not
be possible to get the best adjustment results. Incorrect tracking
adjustment may not be noticeable with some types of picture.
However, pictures with lots of lines and shading will tend to show
incorrect tracking adjustments more clearly, so be sure to check the
tracking adjustment first.
• It may also be possible to fix flickering and fuzziness by adjusting
the brightness, contrast , sharpness and keystone correction
settings.
Adjust
: 0000
: 10
: 0 - +
:
0 - +
: 0 +
-
Select [Normal ]
: : Select
: [Computer ]
: ON OFF
Execute
[Menu]: Exit
37