Replacing The Lamp - Epson EMP-53 User Manual

Maintenance Maintenance

Replacing the Lamp

CAUTION
Wait until the lamp has cooled down sufficiently before removing the
lamp cover. It takes a further one hour after the
has finished for the lamp to be cool enough.
PROCEDURE
Turn off the projector power, wait for the cool-down
1
period to end, and then disconnect the power cable.
The cool-down period lasts for about 20 seconds.
Wait until the lamp has cooled down, and then
2
remove the lamp cover from the base of the projector.
It takes approximately one hour for the lamp to cool down by
itself after the cool-down period has finished.
Insert the screwdriver that is supplied with the spare lamp or a
flat-tipped screwdriver into the gap in between the projector
and the lamp cover, and slide the screwdriver in until the [ ]
mark on the lamp cover and the [ ] mark on the projector are
aligned. Then lift up the lamp cover to remove it.
cool-down period
2
Loosen the two lamp fixing screws.
3
Use the screwdriver that is supplied with the spare lamp or a
flat-tipped screwdriver to loosen the two silver lamp fixing
screws that are securing the lamp to the projector.
1
77