Table of Contents
Advertisement
REMOTE
CONTROL
Z-TRAK
PROGRAMMING
YOUR
Z-TRAK
REMOTE
Your Z-Trak remote is already programmed to work with most
Zenith VCR's. If you have a non-Zenith VCR, or if your Zenith
VCR does not respond to your Z-Trak remote, you will need to
program your remote as follows:
1. Refer to the table of VCR Codes, in this section of
the guide. Locate the 3-digit number
which corre-
sponds to your brand of VCR.
2.
Make sure your TV is turned on.
3.
While pointing
the Z-Trak remote towards
your
Zenith TV, simultaneously
hold the MUTE and
ENTER keys until the TV displays
a VCR "Setup"
screen (about three seconds).
The VCR key will also
light upon entering
the Programming
mode.
4.
Notice that the current
VCR brand code (initially
"201") is displayed
on the TV screen.
Roll the track-
ball up or down (or use CHAN Up/Down)
to choose
the 3-digit number of your VCR.
5. When the correct
3-digit number
is displayed
on the
TV screen, use the POWER key to make sure that
your VCR turns on and off properly.
If it does not
respond,
refer to the VCR Codes table to select a
different
3-digit number.
6. If your VCR turns on and off successfully,
press the
trackball
(or ENTER) to save the current
VCR brand
code.
The setup screen will disappear
from the TV.
Also, the VCR key will flash 3 times upon exiting
the Programming
mode.
The remote will be in the
VCR mode.
7. Now try other controls
on your VCR, such as Play,
Rewind, etc., to make sure that the correct VCR
brand code number was selected.
(If not, repeat
steps 3 to 7.)
8. The MUTE key can be pressed
at any time to cancel
Programming
mode.
The original
VCR brand code
will remain unchanged.
NOTE:
Only the VCR mode can be programmed.
9. The Z-Trak remote will exit Programming
mode
automatically
after 60 seconds
if no key press or
trackball
movement
is detected.
AUTO
FIND
OPTION
If you have tried all 3-digit codes listed for your VCR manufac-
turer, and none of them operate your VCR, you will need to try
"AutoFind" to see if a different code will operate your VCR:
1. Make sure your VCR is turned on.
2. Simultaneously
hold the MUTE and ENTER keys un-
til the VCR key lights up (about three seconds).
f
I
TV displays
VCR code
/
Equipment to be
controlled
Z-Trak Remote
Control
2923-o,-0
11 -- 3
Advertisement
Table of Contents
