Zenith PVR5269 Operation Manual & Warranty page 21

UNIVERSAL REMOTE CONTROL
AUTO FIND OPTION
If you have tried all the codes listed for your brand and type of
product in the code table, and none of those codes operate your
equipment,you can use Auto Find to search for the code you need.
Follow these steps for each product you are using:
1. Turn the product ON and aim the remote toward it.
2. Press and hold PRG with a small blunt object until
the indicator lights (about three seconds).
3. Press the mode key on the remote for the product
you want to control: TV, VCR, CABLE, or AUX.
4. Key in code 0-0-0, then press ENTER within two
seconds. When the indicator light flashes three times
and remains lit, Auto Find is active.
St
,
Press and hold POWER, then release it, repeating
this action about once a second until the product
turns OFF.
Press ENTER immediately to save the code. If your
remote fails to operate the functions you use most
often, you can re-enter Auto Find and search for a
better code.
NOTES:
• The indicator light should flash OFF when you press
POWER and back ON when you release it. If the indicator
light stays on when you press POWER, Auto Find has tried
all available codes. If you finish Auto Find and the product
you want to control has not turned off, your remote cannot
control that product.
• Pressing PRG at any time during the use of Auto Find will
cancel Auto Find, and you will have to start again.
ON
POWER I1_
OFF
Equipment to be
controlled
Typical Remote
Control
_23_1_ 4--5