Table of Contents
Advertisement
Quick
Reference
Guide
This section of the guide discusses
the use of StarSight
with the Z-Trak trackbaU remote. Operation
with the Z-Trak is
different
than with conventional
remote controls. There are far fewer buttons, because the trackball
is used to move an
on-screen
pointer through various menus. The following
illustration
shows the Z-Trak and its controls.
Set remote to operate"IV
VOL
U p/l_t_
When operating "IV: lnciease volume
When operating VCR: Fast forward
VOL Down/q_l
When operating TV: Decrease volume
When operating VCR: Rewind
MUTE
II
When operating TV: "IV mute
When operating VCR: Pause
RECRD
When operating TV: Schedule a
program for recording; confirm or
cancel
recordings
When operating VCR: Sets VCR to record
POWER
TV: TV power On/Off
When operating VCR: VCR power On/Off
Set remote to operate VCR
3ALL
Press ball to activate
CHAN
Up/I_
When operating "IV: Go to the next channel
When operating VCR: Play
CHAN Down/•
When operating "IV: Go to the previous channel
When
operating
VCR:
Stop
ENTER
When operating TV: Tune TV to a program
highlighted on the StarSight screen; when
watching TV displays the program title
"FLSHBK
When operating TV: Tune TV to the last
channel viewed
When operating VCR: TV/VCR Switch
In the following
sections,
you will be exploring
the
various screen menus available
in StarSight.
As you do
so, keep in mind the following
guidelines
(quite literally,
"rules of thumb") for Z-Trak operation:
•
To display the pointer, press the trackball.
•
To highlight
an option or make a selection,
point to
the desired option and press the trackball.
•
To close a StarSight
screen, point to the QUIT icon
and press the trackball.
To tune a channel,
point to a channel icon and press
the trackball.
You can also simply highlight
a
program
and press the ENTER button to tune that
program.
Many StarSight
program guides have more than one
screen full (one "page") of information.
You can
point to the "P_'" or "P,L" icons and press the
trackball
to flip through the pages. You can also
move more slowly by moving the pointer to the top,
bottom, or side edges of the screen and continuing
to
roll the ball in that direction.
Be sure that the pointer is red, indicating
that you are in
StarSight mode. If the pointer is blue, move the pointer
to the left side of the TV screen, point to the TV icon
and press the trackball.
C-I
Advertisement
Table of Contents
