Table of Contents
Advertisement
Setup
2: TV and Cable
Box
NOTE:
DO NOT UNPLUG YOUR CABLE BOX AT
ANYTIME.
le
2.
e
e
Turn off, but do not unplug, your Cable Box.
Attach the cable coming out of the wall O to your
Cable Box's "Input" or "Cable In" jack.
Attach an RF cable O to your Cable Box' s "Output"
or '"IV Set" jack, and the other end of this cable to the
"ANT/CABLE
1" jack on the back of your TV.
Take the Remote Emitter -- it's a wire with a plug at
one end and two plastic bulbs at the other ends -- and
push the plug of the Remote Emitter wire into the
"StarSight Control Port" on the back of the TV. Run
the Remote Emitter wire _ under the Cable Box and
place either one of the plastic bulbs about two inches
in front of the front panel of the Cable Box _. Make
sure that the plastic bulb is facing the front panel of
the Cable Box (see diagram below). Do not adhere the
Remote Emitter at this time. After you have
completed
subscribing
to StarSight, and you have
confirmed the correct code that operates your Cable
Box, you can peel off the backing of the sticker on the
Remote Emitter and adhere it permanently.
5,
Turn on your Cable Box.
6.
Plug your TV into a power outlet not controlled by a
light switch.
NOTE:
DO NOT PLUG YOUR TV INTO THE
BACK
OF YOUR CABLE BOX.
o
So
Tune your Cable Box to the PBS channel listed on
your StarSight Checklist.
Turn on your TV. Using the number pad on your
Universal TV remote control, tune your TV to the
channel that allows you to watch Cable TV, usually
channel 3 or 4. If these channels don't show your
Cable TV service, then try putting your TV on
channel 2, 5, or 6.
9.
Proceed to "Step 3. Activate StarSight."
TO FRONT OF
CABLE BOX
CABLE A
©00
I
I
Loop OUT
IN
BOX
FRONT
A-3
Advertisement
Table of Contents
