Table of Contents
Advertisement
PIP OPERATION
INTRODUCTION
Your TV must be connected to two separate sources in order to view a different picture in the PIP inset from that which is
showing in the main picture area of the TV. One source (such as an antenna) must be connected to the ANT/CABLE
I or 2
jack. The other source (such as a VCR) must be connected to one set of the Video or Super Video jacks.
If you have not already selected the input Sources for your main TV picture and the PIP inset, refer to the instructions below. Make
sure you select those sources that correspond to the jacks on the TV connection panel that are receiving the input signals.
L_lin ,_muroe
Ant/Cable z
Video 1
Video 2
S-Video 1
Video 3
S-Video2
41_Main/PIP
PIP Source
Ant/Cable1
Video1
Video2
S-Video 1
Video3
S-Video2
'1'4, T oSelect Source I
Source of main picture
shows here
Source of PIP picture
shows here
SELECTING
MAIN
PICTURE
AND
PIP INSET
SOURCES
Universal
Remote
• Make sure remote is in TV
mode.
• Press SOURCE on your re-
mote to view the Source
Menu.
• Press SOURCE repeatedly to
select the source which
corresponds to the jack on the
TV connection panel that is
receiving the input signal.
• Press QUIT to remove the
menu.
SELECT
MAIN SOURCE
Z-Trak
Remote
• Make sure remote is in TV
mode.
* Point and press on the
SOURCE icon (at the top of
the screen).
• Point and press on the Main
Source which corresponds to
the jack on the TV connection
panel that is receiving the
input signal.
* Move the pointer off the menu
and press the TrackbaU to
remove the menu.
SELECT PIP SOURCE *
Universal
Remote
Make sure remote is in TV mode.
Press SOURCE on your remote
to view the Source Menu.
Press the Left or Right key to
select PIP Source column.
Press SOURCE repeatedly to
select the source which
corresponds to the jack that is
receiving the PIP input signal.
Press QUIT to remove the menu.
Z-Trak
Remote
• Make sure remote is in 'IV mode.'
• Point and press on the SOURCE
icon (at the top of the screen).
• Point and press on the PIP
Source which corresponds to the
jack on the TV connection panel
that is receiving the input signal.
j • Move the pointer off the menu
and press the Trackball to
remove the menu.
* A PIP inset appears while the Source icon is selected to show the effect of selecting a PIP source.
PICTURE-IN-PICTURE
FUNCTIONS
While using the various PIP functions,
refer to the illustration
below and the instructions
on the following
pages.
Note that the op-
eration of these functions
differ, depending
which remote control you are using.
Arrow Keys
l:
_
[ ff_"i
SWAP
11!
PIP
SOURCE
[
PIP Functions, Universal Remote Control
Select these options
with the Z-Trak remote
to perform the PIP
functions described on
the following page.
-I'ir'r_r
Captions
Z-Trak
PI P On
Freeze
MovePIP
Swap
PIP Functions, Z-Trak Remote Control
continued on next page
29234)1-O
3 m 1
Advertisement
Table of Contents
