Table of Contents
Advertisement
Setup
4: TV and VCR
and Cable
Box
NOTE:
DO NOT UNPLUG
YOUR CABLE
BOX AT
ANY TIME.
lo
2.
e
o
.
,
Turn off your Cable Box.
Attach the cable coming out of the wall O to the
"ANT/CABLE
2" jack on the back of your TV.
Attach an RF cable Q to your TV's "LOOP OUT TO
DECODER"
jack, and the other end of this cable to
your Cable Box's "Input" or "Cable In" jack.
Attach an RF cable I_ to your Cable Box's "Output"
or "TV Set" jack, and the other end of this cable to the
"VHF In" (FROM ANTENNA) jack of your VCR.
Attach an RF cable _ to your VCR's "VHF Out" (TO
TV) jack, and the other end of this Cable to the
"ANT/CABLE
1" jack on the back of your TV.
Take the Remote Emitter -- it's a wire with a plug at
one end and two plastic bulbs at the other ends -- and
push the plug of the Remote Emitter O wire into the
"StarSight Control Port" on the back of the TV. Run
one Remote Emitter wire under the VCR and place
one of the plastic bulbs about two inches in front of
the front panel of the VCR Q. Make sure that the
plastic bulb is facing the front panel of the VCR. Do
the same for the Cable Box. Do not adhere the Remote
Emitters at this time. After you have completed
activating StarSight, and you have confirmed the
correct codes that operate your VCR and Cable Box,
you can peel off the backing of the stickers on the
Remote Emitters and adhere them permanently.
7.
ocate the section on the back of your TV labeled
"Video 1 In." Attach the three Audio/Video cables to
the "Video," "Audio R" and "Audio L" jacks
and attach the other ends of the cables to the
corresponding
"Video Out," "Audio R Out" and
"Audio L Out" jacks on the back of your VCR. This is
necessary if...
•
You have a VCR without a front panel channel
indicator
that uses an on-screen
display.
You have a stereo VCR and would like to take
advantage
of the stereo feature.
You would like to take advantage
of PIP.
8.
Plug your VCR into a power outlet and leave it off.
9.
Turn on your Cable Box.
10. Plug your TV into a power outlet not controlled by a
light switch.
NOTE:
DO NOT PLUG YOUR TV INTO THE
BACK OF YOUR CABLE
BOX.
11.
12.
Tune your Cable Box to the PBS channel listed on
your StarSight Checklist.
Turn on your TV. Using the number pad on your
Universal TV remote control, tune your TV to the
channel that allows you to watch Cable TV, usually
channel 3 or 4. If these channels don't show your
Cable TV service, then try putting your TV on
channel 2, 5, or 6.
13.
Proceed to Installation "Step 3. Activate StarSight."
TO FRONT OF VCR
AND CABLE BOX
CABLEA
A-5
Advertisement
Table of Contents
