Table of Contents
Advertisement
Setup
3: TV and VCR
4.
3_
Attach the cable coming out of the wall O to the
"VHF In" (FROM ANTENNA) jack of your VCR.
Attach an RF cable O to your VCR's "VHF Out" (TO
TV) jack, and the other end of this cable to the
"ANT/CABLE
I" jack on the back of your TV.
Take the Remote Emitter -- it's a wire with a plug at
one end and two plastic bulbs at the other ends -- and
push the plug of the Remote Emitter wire _ into the
"StarSight
Control Port" on the back of the TV. Run
the Remote Emitter wire under the VCR and place
either one of the plastic bulbs about two inches in
front of the front panel of the VCR. Make sure that the
plastic bulb is facing the front panel of the VCR O.
Do not adhere the Remote Emitter at this time. After
you have completed activating StarSight, and you
have confirmed the correct code that operates your
VCR you can peel off the backing of the sticker on the
Remote Emitter and adhere it permanently.
Locate the section.on the back of your TV labeled
"Video 1 In." Attach the three Audio/Video
cables to
the "Video," "Audio R" and "Audio L" jacks
and attach the other ends of the cables to the
corresponding
"Video Out," "Audio R Out" and
"Audio L Out" jacks on the back of your VCR. This is
necessary if...
•
You have a VCR without a front panel channel
indicator
that uses an on-screen
display.
•
You have a stereo VCR and would like to take
advantage
of the stereo feature.
You would like to take advantage
of PIP.
5o
Plug your VCR into a power outlet and leave it off.
6°
Plug your TV into a power outlet not controlled by.a
light switch and turn your TV on.
7.
Proceed to "Step 3. Activate StarSight."
TO FRONT OF VCR
CABLE A
AUDIo L AUOIoR VIDEo
our
_D_01
IN
VHFIN
T
VHF OUT
VCR FRONT
A-4
Advertisement
Table of Contents
