Scrub Deck Skirts - Windsor chariot iSCRUB CS24 10060210 Operating Instructions Manual

SCRUB HEAD-CYLINDRICAL
The dual cylindrical scrub head is designed to
eliminate debris that may be caught in the squeegee
while scrubbing. Water is applied to the first
scrubbing brush turning in a clockwise rotation when
viewed from the right of operator's side of machine.
The first brush scrubs dirt and debris between the
brushes. The second scrubbing brush, turning in a
counter clockwise rotation, picks up debris and
throws it into a removable hopper. The larger debris
which might catch under the squeegee is collected
in the hopper. Water is allowed to drain out the
hopper into the squeegee path where it is recovered
from the floor.
MAINTENANCE
The brushes should wear evenly side to side if
properly adjusted. Scrub brushes should be
exchanged front to back every 50 hours to ensure
even wear since the rear brush contacts the floor
with more force. It is not necessary to rotate end for
end since swapping front to back puts the brushes in
the opposite rotation, as well as balancing wear.
Scrub brushes should be replaced as a set when
bristle length wears to height of yellow
TM
PerformAlert bristles.
SCRUB BRUSH REMOVAL
The scrub brushes are removed from the side of the
machine. The front is removed from the right side
and the rear is removed from the left side.
1. Unscrew the knob and swing side squeegee out
about 90°
2. Unscrew knob on side door but do not remove.
3. Pull out on top of door until lip on door clears
brush head.
4. Push down on door until hooks on bottom of
door are free of scrub head side.
5. Pull out on door with a rocking motion to free
idler door from end of brush.
6. Pull brush out with a rocking motion to free
brush from drive hub.
MAINTENANCE-SCRUB DECK - CYLINDRICAL
SCRUB BRUSH REPLACEMENT
1. Unscrew the knob and swing side squeegee out
about 90°
2. Lift the drive side of the brush. Push brush until
a positive stop is felt. The idler plate cannot be
installed until the brush is fully seated on the
drive hub.
3. Allow brush to drop below scrub deck. Fully
insert plate onto brush.
4. Line up bottom hook on idler door with notches
on side of scrub head.
5. Slide idler door up until lip rests on top of scrub
head.
6. Hand tighten knob to secure door into place.
TO ADJUST SCRUB DECK SIDE SQUEEGEES
These skirts should be adjusted to 3/8" deflection.
To adjust:
1. Lower scrub deck to floor.
2. Stop machine.
3. Loosen scrub deck skirt stop.
4. Adjust stop such that skirt deflection is about
3/8".
TO REPLACE SCRUB DECK SIDE SQUEEGEES
These skirts have four wear edges.
To use another edge:
1. Remove each of the scrub deck skirt
assemblies.
2. Remove the hardware that retains the blade on
each assembly.
3. Flip the blade vertically or horizontally, or both,
and replace hardware.
4. Re-install each scrub deck assembly.
86037660 CHARIOT 11/09/06
4-14