Emptying And Cleaning Tanks - Windsor chariot iSCRUB CS24 10060210 Operating Instructions Manual

MACHINE OPERATION

EMPTYING AND CLEANING TANKS

1. Park the machine next to a floor drain. Drain
hoses are at the front of the machine.
2. Turn the machine power off.
RECOVERY TANK
1. Pull the large drain hose from under the front of
the tank. Unscrew cap, then lower hose in
direction of the drain. Do not stand in front of
end of hose. Recovered solution will come out
with force.
2. Remove the recovery tank dome. Flush the
recovery bag out with clean water. Do not use
water hotter than 140°F (60°C) to clean tank.
Damage may occur.
3. Clean debris from dome basket.
4. Clean off the float shut-off system and inspect
for free movement of float. The float shut-off
system is located in the rear of the recovery
tank.
5. Replace the drain cap and secure drain hose
under tank.
6. If machine is to be stored, leave the recovery
tank dome off.
3-19
SOLUTION
DRAIN HOSE
RECOVERY
DRAIN HOSE
86037660 CHARIOT 11/09/06
SOLUTION TANK
1. Pull recovery drain hose out to expose the
solution drain hose.
2. Pull the solution drain hose from under front of
the tank. Unscrew the T-handle on plug enough
to loosen plug, then lower hose in direction of
drain. Slowly remove plug from drain hose.
3. Remove the solution tank cover.
4. Flush the solution tank out with clean water and
run several gallons of clean water through
systems. Do not use water hotter than 140°F
(60°C) to clean tank. Damage may occur.
NOTE: Never allow solution to remain in tank.
Damage to tank, seals and valves could occur.
Tuck drain hose under tank and secure with
recovery drain hose by tucking it under tank.