Gas Burners - Vulcan-Hart 1GR45A Service Manual

GRA SERIES GAS FRYERS - REMOVAL AND REPLACEMENT OF PARTS
2. Pull filter drawer out, remove filter tank
assembly and push the tank support arms back
into place under the fryer.
3. Remove splash guard from base frame.
4. From underneath the fryer:
A. Disconnect the discard valve switch lead
wire connector from power supply box.
B. Remove switch mounting screws.
5. Reverse procedure to install and check for
proper operation.

GAS BURNERS

1. Open the door to the fryer section being
serviced.
F25377 (March 2010)
2. Remove cooking controls to access burner(s) if
necessary.
3. Remove drain pipe to access burner(s) if
necessary.
4. Remove gas burner shipping ties (if installed).
5. Lift gas burner up and tilt the top of burner
toward fryer tank until it clears the gas orifice at
the bottom.
NOTE: The burners mount to the burner mounting
bracket by shoulder bolts that rest in the keyway slot.
Page 6 of 36