OSD (On-Screen Display) Control "Punch
Through"
This "Punch Through" enables you to program the
URC-SR3 so that CBL/SAT or DVD/DVR/VCR
OSD Controls (GUIDE, MENU, INFO, EXIT, My
Button, Sel and 4 Cursor Controls) will also operate
in other component modes on the remote control.
STEP 1: Press and hold the component button you
want to add OSD Control to, such as TV or DVD,
and the SELECT [SEL] button at the same time for
two seconds until the Component LED light turns on.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 2: Press the MENU button. The component
LED will blink once.
COMPONENT
BUTTONS
MENU
SELECT
STEP 3: Press either the CBL/SAT or DVD button
that you want to use as the source of OSD Control.
The component LED will blink two times to confirm it
is saved.
Page 23