Audio Connectors - Intel D810E2CA3 Specification

Intel Desktop Board D810E2CA3 Technical Product Specification

1.9.2 Audio Connectors

The audio connectors include the following:
ATAPI-style connectors:
CD-ROM
Auxiliary line in
Front panel audio
Back panel connectors:
Line out
Line in
Mic in
NOTE
The line out connector, located on the back panel, is designed to power either headphones or
amplified speakers only. Poor audio quality may occur if passive (non-amplified) speakers are
connected to this output.
For information about
The back panel audio connectors
1.9.2.1 ATAPI CD-ROM Audio Connector
A 1 x 4-pin ATAPI-style connector connects an internal ATAPI CD-ROM drive to the audio
mixer.
For information about
The location of the ATAPI CD-ROM connector
The signal names of the ATAPI CD-ROM connector
1.9.2.2 Front Panel Audio Connector
A 2 x 5-pin connector for routing mic in and line out to the front panel.
For information about
The location of the front panel audio connector
The signal names of the front panel audio connector
1.9.2.3 Auxiliary Line In Connector
A 1 x 4-pin ATAPI-style connector connects the left and right channel signals of an internal audio
device to the audio subsystem.
For information about
The location of the auxiliary line in connector
The signal names of the auxiliary line in connector
30
Refer to
Section 2.8.1, page 49
Refer to
Figure 9, page 54
Table 28, page 55
Refer to
Figure 9, page 54
Table 29, page 55
Refer to
Figure 9, page 54
Table 30, page 55