Ricoh Aficio MP C5502 User Manual page 291

10. Troubleshooting
Message
"Selected file is currently in
use. Password cannot be
changed."
"Selected file is currently in
use. User name cannot be
changed."
"Sending the data has
failed. The data will be
resent later."
"Some invalid destination(s)
contained. Do you want to
select only valid
destination(s)?"
"Some of selected files are
currently in use. They could
not be deleted."
"Some page(s) are near
blank. To cancel, press the
Stop key."
"The entered file name
contains invalid character(s).
Enter the file name again
using any of the following 1
byte characters. " 0 to 9 ", "
A to Z ", " a to z ", " . - _""
220
Causes
You cannot change the
password of a file whose
status is "Waiting..." or that is
being edited with
DeskTopBinder.
You cannot change the
sender's name whose status
is "Waiting..." or that is
being edited with
DeskTopBinder.
A network error has
occurred and a file was not
sent correctly.
The specified group contains
e-mail destinations and Scan
to Folder destinations, either
of which are incompatible
with the specified
transmission method.
You cannot delete a file
which is waiting to be
transmitted ("Waiting..."
status displayed) or whose
information is being
changed with
DeskTopBinder.
The first page of the
document is almost blank.
The file name contains a
character that cannot be
used.
Solutions
Cancel transmission ("Waiting..." status
cleared) or the DeskTopBinder setting,
and then change the password.
Cancel transmission ("Waiting..." status
cleared) or the DeskTopBinder setting,
and then change the user name.
Wait until sending is retried
automatically after the preset interval. If
sending fails again, contact your
administrator.
In the message that appears at each
transmission, press [Select].
Cancel transmission ("Waiting..." status
cleared) or the DeskTopBinder setting,
and then delete the file.
The original's blank side might have
been scanned. Be sure to place your
originals correctly.
Check the file name set at the time of
scanning. For details about characters
that can be used in file names, see
"Specifying the File Name", Scan .