Enterasys X-Pedition 2000 Getting Started Manual page 71

Enterasys x-pedition 2000 getting started guide

Table of Contents

Use the following procedure to specify the SYSLOG server and the types of messages you want the

CLI to log on the server.

Ensure that you are in Enable mode by entering the enable command in the CLI.

Use the following command to verify that the XP-2000 can reach the SYSLOG server by

pinging the server:

ping

Ensure that you are in Configure mode by entering the configure command in the CLI.

If you have not already done so, use the interface add ip command to set the IP address and

netmask for the en0 Ethernet interface, as shown in the following example:

xp-1(config)# interface add ip en0 address-netmask 10.50.11.22/16

Note:

Use the following commands to "add" the SYSLOG server to the XP-2000, set the message

level, and set the SYSLOG facility:

system set syslog server

system set syslog level fatal|error|warning|info

system set syslog facility

Here is an example:

xp-1# config

xp-1(config)# system set syslog server 10.50.11.12

xp-1(config)# system set syslog level info

xp-1(config)# system set syslog facility local0

Enterasys X-Pedition 2000 Getting Started Guide

<IP-addr>

The en0 interface is automatically created by the system and is reserved for the

XP-2000's management port.

<hostname-or-IP-addr>

<facility-type>

Setting SYSLOG Parameters

Table of Contents