Table of Contents
Advertisement
To install the XP-2000 in an equipment rack:
1.
If your XP-2000 is not already equipped with rack-mounting brackets, take the following
steps. Otherwise skip to
a.
Align one of the mounting brackets over the corresponding holes in the side of the XP-
2000. The mounting bracket is correctly positioned when the side with two open mounting
holes is flush with the front of the XP-2000.
b.
Use the phillips-head screwdriver and the supplied phillips-head screws to attach the
mounting bracket to both the side and bottom of the chassis. (There are four holes for each
rack mounting bracket—the one on the side of the chassis that you exposed in
three holes in the bottom of the chassis.)
Note:
c.
Attach the other mounting bracket.
2.
Along with an assistant, lift the XP-2000 into place in the mounting rack.
3.
While your assistant holds the chassis in place, use the phillips-head screwdriver and four
phillips-head screws to attach the mounting brackets to the mounting rack.
: Make sure the screws are tight before your assistant releases the chassis. If you
Caution
accidentally leave the screws loose, the chassis can slip and fall, possibly becoming damaged.
Enterasys Xpedition 2000 Getting Started Guide
G2M-HTXA2-08
10/100BASE-TX
1
2
3
4
5
6
7
8
3
10/100BASE-TX
1
2
3
4
5
6
7
8
1
Figure 9. Installing the XP-2000 chassis in an equipment rack
step
2.
Be sure to use the phillips-head screws supplied by Enterasys. If you use screws
that are longer than the ones included with your shipment, there is a danger of
damaging the XP-2000's internal components.
Enterasys Networks
G2M-GSXA1-02
Tx
Link
1
Rx
AN
10/100 MGMT
1
2
3
4
CONSOLE
OK
HBT
ERR
DIAG
Installing the Hardware
1000BASE-SX
Tx
Link
2
4
Rx
AN
5
6
7
8
10/100BASE-TX
2
step
a, and
27
Advertisement
Table of Contents
