Table of Contents
Advertisement
Setting Up SNMP Community Strings
Here is an example of the commands and output for configuring SNMP and saving the changes.
xp-1# config
xp-1(config)# snmp set community public privilege read-only
xp-1(config)# snmp set target 10.50.11.12 community public
xp-1(config)# save active
xp-1(config)# exit
xp-1# snmp show all
SNMP Agent status:
enabled mode
SNMP Last 2 Clients:
10.50.100.53 Mon May 14 10:31:27 2001
10.50.100.43 Mon May 14 10:31:22 2001
SNMP Chassis Identity:
not configured.
Trap Table:
Index Trap Target Addr Community String Status
----- none configured -----
Traps by Type:
Authentication trap: enabled
Link Up/Down trap: enabled
Community Table:
Index Community String
1. public
SNMP statistics:
247019 packets received
247018 packets sent
7.
After verifying the SNMP configuration, save the changes to the Startup configuration file by
entering the copy active to startup command.
Remember to enter yes or y when the CLI asks you whether you want to overwrite the Startup
configuration.
50
Privilege
READ-WRITE
246346 get requests
745 get-next requests
184 get-bulk requests
50 set requests
0 bad SNMP versions
1 bad community names
0 ASN.1 parse errors
0 PDUs too big
246346 get responses
745 get-next responses
184 get-bulk responses
50 set responses
Enterasys X-Pedition 2000 Getting Started Guide
Advertisement
Table of Contents
