Table of Contents
Advertisement
3.
Use the following commands to add an SNMP community string and set a target for the traps.
snmp set community
snmp set target
Note:
4.
Enter the show command to examine the changes accumulated in the scratchpad.
5.
Enter the save active command to activate the commands you entered in the previous steps.
6.
To verify the changes, enter the snmp show all command.
Enterasys X-Pedition 2000 Getting Started Guide
<community-name>
<IP-addr>
community
The target IP address must be locally attached to the XP-2000. You cannot specify a
target that is connected to the XP-2000 by another router. If the IP address is more
than one hop away from the XP-2000, configure the
XP-2000 with a static route to the target so that a cold start trap is sent.
Setting Up SNMP Community Strings
privilege read
<community-name>
49
Advertisement
Table of Contents
