Hardware Overview
LEDs
The 100BASE-FX expansion module uses the following LEDs.
Table 8. 100BASE-FX expansion module LEDs
Lnk
Act
1000BASE-SX Expansion Module
The 1000BASE-SX expansion module contains two independent Gigabit (1000-Mbps) Ethernet
ports. The ports connect to multimode-mode fiber (MMF) cables.
the 1000BASE-SX expansion module.
G2M-GSXA1-02
14
LED
Each port has two LEDs located to the left of the connector. The
green Lnk LED indicates the link status. When this LED is lit, the
port hardware is detecting that a cable is plugged into the port and the
port has established communication with the device at the other end.
The amber Act LED flashes each time the port's transceiver sends or
receives packets.
Tx
Link
Rx
AN
Gigabit port
Figure 4. Front panel of 1000BASE-SX expansion module
Description
1
2
Tx
Link
Rx
AN
Gigabit port
Enterasys X-Pedition 2000 Getting Started Guide
Figure 4
shows the front panel of
1000BASE-SX