Installing The Blade - Craftsman 113.248212 Owner's Manual

BOTH MQDIEm=S
iNSTALLING THE BLADE
I WARNING: To avoid injury from accidental start- I
ing, make sure the power cord is unplugged
J
before removing any part from the saw.
1,, Remove the blade guard by loosening the two (2)
mounting screws with a phillips screwdriver and lifting
the blade guard upward,_
GUARD
MOUNTING
SCREW
JARD
MOUNTING
2 Loosen the upper blade guide assembly and
lower to approximately 3 inches above rear table
and retighten Iock knob This is necessary to
make adjustments to blade guide and back up
roller bearing
_I tf Lock K.o.
_{I_; ¸ _!, __l f
Ill . ........
3, Loosen the two capscrews that lock the upper
blade guides using a 1/8-inch hex "L" wrench
and separate them about I/8-inch Repeat the
same step for the lower blade guides
BLADE GUIDE
CAPSCREWS
2O