Craftsman 113.248212 Owner's Manual page 15

BOTH M@@EL
5,, Place the Poly "V" belt into the motor mount as
shown on the underside of the band saw
6 Look atthe motor mount and find the slot that is nar-
rower than the other three. When mounting the
motor, the motor stud without a spacer goes into this
slot.
MOTOR MOUNT
7 Carefully position the motor so that the poty "V" belt
is around the motor pulley and the four motor studs
align with the slots in the motor mount
8 Push motor studs through and install the flanged
lock nuts to the three (3) motor studs with spacers
Start the flanged nuts by hand only at this time
9. Install the threaded stud through the hole in the
lower leg of the motor mount and over the motor stud
as shown
NARROW
SLOT
SPACERS
MOTOR MOUNT
THREAOEO STUD
MOTOR MOUNT
15