FULLONE
YEAR WARRANTY
ON CRAFTSMAN
BAND SAW
If within one year from the date of purchase,
this Craftsman
Saw fails due to a defect
in material
or workmanship, Searswillrepairit, free ofcharge.
WARRANTYSERVICEtS AVAILABLE BYSIMPLYCONTACTING THE NEARESTSEARSSERVICE
CENTER/DEPARTMENT T HROUGHOUT THE UNITEDSTATES.
Thiswarrantyapplies only whilethis productis used in the UnitedStates,
Thiswarrantygivesyou specificlegalrights,andyou may also haveotherrightswhichvaryfrom
stateto state,.
Sears_
Roebuckand
CO..,
Dt817WA Hoffman
Estates,
IL 60179
TABLE OF CONTENTS
Sectton Tttle
Page Number
Safety Instructions for Band Saw ............................................
2
Glossary of Terms for Woodworking
.............................. 6
Electrical Connections .................................................................
6
General Information ..............................................................................
8
Model Description .....................................................................
8
Assembly and Alignment .........................................................
11
Assembling Leg Set .........................................................
1!
13
13
14
17
18
18
...................................................
18
18
19
20
....................................................
22
24
26
26
Safety Instructions
SAFETY
SIGNAL
WORDS
DANGER:
means if the safety information
is not fol-
lowed someone will be seriously injured or killed
WARNING:
means if the safety information
is not
followed someone could be seriously injured or killed.
CAUTION:
means if the safety information is not fol-
lowed someone might be injured
Safety is a combination of common sense, staying alert
and knowing how your band saw works.
Read this
manual to understand this saw,
Location and Function of Controls ............................... 2 7
On-Off Switch ............................................................. 27
27
27
Basic Band Saw Operation ....................................................
28
Circle Cutting ..............................................................................
31
..................................................................
31
......................................
32
32
Installing 1/16" Blade and
............................................................................
33
Scrolling .....................................................................................
34
Recommended
..............................................
36
Maintenance ..................................................................................
36
Trouble Shooting - All Models ......................................... 37
38
Parts Lists ................................................................................................
40
Drive Assembly .....................................................................
40
Base Components
..............................................................
42
Bevel Drive and Motor Mount
Assembly Parts ..................................................... 44
Leg Set ................................................................................
46
BEFORE
USING THE SAW:
for Band Saw
Assembly and alignrnent,
(See pages 11 - 18)
,
Learn the use and function of the ON-OFF switch,
bevel handwheel,
bevel lock knob, blade guides,
backup bearings, guide bar lock knob, and blade
guard (See page 19 .)
• Review and understanding
of all safety instructions
and operating procedures in is manual
• Review of the maintenance
methods for this saw,
(See page 36.)
Read the following WARNING labels found on the front
of the saw:
WARNING:
To avoid mistakes that could cause
serious, permanent Injury, do not plug the saw In
until the following
steps are completed.
t Read men_e] before using saw
5. Do nat remove tammed cutoff pieces until
9, Turn power off and walt for biade 1ostop
2 Wear safely goggles that meet ANSi
blade has stopped,
before adjusting or servicing
Z87o1 standards
6. Maintain proper adjustment
of blade tension,
10, Malnlaln 1116 inch maximum distance
3. Be sure blade Is Installed with teelh
blade guides, and thrust beadngs
between table and sanding belt,
pointing down.
7 Ad|usl uppor guide to just clear the wosd
4. Keep lingers away frQm the moving blade.
8, Hold workplace firmly against the labla_