Craftsman 113.248212 Owner's Manual page 11

assembay and aSignntent
BOTH MODELS
ATTACHING LEVELING FEET
From the loose parts bag find tf_e 1ollowing hardware:
ITEM DESCRIPTION QTY.
A Support Brackel ........................ 4
B Leveling Feet ....... 4
C Hex Nut318-16 ......... 8
From the loose parts find the following items:
D Leg ........
4
_B
C
1 Mount floor leveler support brackets inside legs,
Line up the three tabs on brackets with slots on leg
and tap into place Make sure lip on bracket points
up Install the remaining three brackets the same
way
®
®
®
LEG
2 Put a hex nut on each of the leveling feet and screw it
down towards the rubber foot,,
3,, Put the leveling feet through the holes in the bottom
of the floor leveler support brackeL
4,, Put another hex nut on each of the leveling feet and
hand tighten until they are next to the support bracket
WARNING: After the legset has been attached to
the basic saw assembly, it will be necessary to
adjust the leveling feet so the saw does not rock.
HEXNUTS
SUPPORT BRACKET
LEVELING FOOT
I1