Craftsman 113.248212 Owner's Manual page 12

BeTH MODELS
ATTACHING LEG SET
From the loose parts bag find the following hardware:
Item Description Qty,,
A Truss Head Bolts 1,/4-20 x I/2 32
B Lockwashers External V4 32
C Hex Nuts V4-20 ..... 32
From the loose parts find the following items:
D Leg Channel . 1
E Legs (with attached support brackets and
leveling feet) 4
F Lower Stiffeners 4
¢
E
'_NOT SHOWN TO SCALE
t
2
Lay a piece of cardboard on the floor to keep from
scratching the saw.
Position the basic saw assembly on the floor as
shown below The back cabinet of the saw should be
laying flat on the floor it may be necessary to have
someone help you lift the saw.
SWITCH
SIDE
FRONT
FRONT LEGS AND
CHANNEL ARE
ATTACHED HERE
LEG
REAR LEGS ARE
kTTACHED HERE
FLOOR
Mount the two front legs to the basic saw assembly
using truss head bolts, lockwashers, and nuts.
Make sure that the four (4) holes in each corner of
the saw line up with the four (4) holes in the top of
each leg At this time only put bolts through thesides
of the saw assembly notthe front Only fingertighten
nuts
4 Position the leg channel inside the legset as shown
Fasten the channel piece, leg, and saw together
with two (2) truss headbolts on each side.. The
threaded section of the bolts should point towards
the inside of the basic saw assembly Put a lock-
washer and hex nut on each bolt.. Finger tighten nuts
at this time
SAW
LOCKWASHER
CHANNEL
LEG
i--j
-_ TRUSS
'_"-" HEAD
SCREW
Truss head screw iockwasher, hex nut and #ont channe/ ptece
12