Lamp Status Read Command; Cr_Lamprepl Command; Cr_Lamph Command; Cr_Lampcorresph Command - Sanyo PLC-WTC500AL - 5000 Lumens Manual

PLC-WTC500L Expand Serial Command Functional Specifications

9.9 Lamp Status Read Command

9.9.1 CR_LAMPREPL Command

Command "CR_LAMPREPL" [CR]
Details Get information of Lamp Replacement time
Acceptable
Response %1
Unacceptable

9.9.2 CR_LAMPH Command

Command "CR_LAMPH" [CR]
Get Lamp running time (in hours)
Details
* return actual lamp running time
Acceptable
Response %1_%2
Unacceptable

9.9.3 CR_LAMPCORRESPH Command

Command "CR_LAMPCORRESPH" [CR]
Get Lamp running time (in hours)
Details
*return lamp running time multiplied by a coefficient (not actual running time)
Acceptable
Response %1_%2
Unacceptable
"000_%1" [CR]
"2Y" ----------------- indicates over lamp replacement time
"2N" ----------------- indicates under lamp replacement time
"2" means the number of lamps
(2 lamp is used→ "2")
"Y"/"N" means if it is time to replace lamp or not.
Example:
"2Y" ----- 2 lamps is used and it is over lamp replacement time
"Error Code" [CR]
"000_%1_%2" [CR]
Lamp 1 data comes first, and then one space, after that lamp
2 data is followed.
%1 = lamp No.1
%2 = lamp No.2
eg; "00410_00410" [CR]
▪▪▪▪ → Lamp No.1 = 410 Hours
Lamp No.2 = 410 Hours
Note;
-each data shall be 5 digits.
"Error Code" [CR]
"000_%1_%2" [CR]
Lamp 1 data comes first, and then one space, after that lamp
2 data is followed.
"00000 – 99999" ▪▪▪▪ %1= Lamp No.1
"00000 – 99999" ▪▪▪▪ %2= Lamp No.2
"Error Code" [CR]
61/75