Cr_Imggmd Command; Pc Adjust Status Read Command; Cr_Fsync Command; Cr_Tdots Command - Sanyo PLC-WTC500AL - 5000 Lumens Manual

PLC-WTC500L Expand Serial Command Functional Specifications

9.4.14 CR_IMGGMD Command

Command "CR_IMGGMD" [CR]
Details Get setting status of Dynamic/Standard/Real/Cinema in Image Gamma
Acceptable
Response %1
Unacceptable

9.5 PC Adjust Status Read Command

9.5.1 CR_FSYNC Command

Command "CR_FSYNC" [CR]
Details Get value of Fine Sync
Acceptable
%1
Response
Unacceptable

9.5.2 CR_TDOTS Command

Command "CR_TDOTS" [CR]
Details Get value of Total Dots
Acceptable
%1
Response
Unacceptable

9.5.3 CR_CLPPHASE Command

Command "CR_CLPPHASE" [CR]
Details Get value of Clamp Phase value
Acceptable
Response %1
Unacceptable
"000_%1" [CR]
"DYN" ------------ Dynamic
"STD" ------------ Standard
"REL" ------------ Real
"CNM" ------------ Cinema
"Error code" [CR]
"000_%1" [CR]
"0000 – 0031"
"Error Code" [CR] --- When command is not available in the given
condition (such as being selected input)
"?" [CR] --- When unknown command is received
"000_%1" [CR]
"mmmm" – "nnnn"
(mmmm = Display area H + Position H)
(nnnn = Maximum value less than 140 MHz of Dot Clock)
"Error Code" [CR] ------------------------ When command is not
available in the given condition (such as being selected input
"?" [CR] ------------------- When unknown command is received
"000_%1" [CR]
"0001"~"nnnn"
("nnnn" depends on input signal)
"Error Code" [CR]
49/75