Smart Technologies SMART Board Installation Manual page 18

7. Attach the second hanger bracket in the same way.
8. Place the mounting bracket over the flat-panel display with the left hanger bracket on your
right side. The left bracket goes on your right because you are looking at the back of the
flat-panel display. The hanger brackets should face towards the flat surface so that the
horizontal section of each bracket makes a U-shape, as shown in the figure below.
Both hanger brackets
make a U-shape
CAUTION
9. Using the supplied Installation Template as a guide, align the slotted holes in the mounting
bracket with the adapter plate bolt holes in the flat-panel display.
IMPORTANT
CAUTION
10
Mounting Bracket
Center Section
If the mounting bracket is mistakenly installed upside-down, the hanger
brackets won't be able to support an overlay and the installation will be unsafe.
PX350 Installation Template
Align the top right corner of this template with the face down
plasma panel as shown below.
1
Align the top of the universal bracket with line A.
2
Ensure the bracket is centred left to right on the plasma panel.
3
Slide the universal bracket up the plasma panel, looking
through the slotted holes for the top mounting points on the
back of the plasma panel. Do not pass line B.
4
Finish installing the PX350 as per your instruction manual.
Note:
If your plasma panel has 8 mounting holes, 2 mounting
options may exist. Use the option which does not obscure
adjacent mounting holes.
© 1997-2005 SMART Technologies Inc. All rights reserved. Expression and the SMART logo are trademarks of SMART Technologies Inc.
Obtain the best possible alignment before mounting either the flat-panel
display or the overlay. After you mount the overlay, you'll be limited in how
much you can move the overlay relative to the flat-panel display. If the overlay
is aligned poorly, it obscures some of the flat-panel display's screen.
Try not to position the mounting bracket over the flat-panel display's cooling
vents. Blocking these vents could cause overheating and damage to the
flat-panel display.
Installing the Interactive Whiteboard
1
Installation Template
Do not pass this line
Position Universal Bracket
between lines A and B
3
99-00617-00-A0
Left hanger bracket
is on the right side
(when viewed
from the back)
99-00667-00 B0