Changing The Corner Knives (745-22 And 745-23) - Duerkopp Adler 745-22 Service Instructions Manual

6.3 Changing the Corner Knives (745-22 and 745-23)

30
Blunt corner knives are to be replaced with the knife set in the
accessories pack.
Please find the order numbers for the corner knife sets in Chapter 1 of
these Service Instructions.
Caution Risk of Injury !
Turn the main switch off.
Change the corner knives only with the main switch turned off.
Danger of cuts!
Do not reach into the sharp blades of the corner knives.
–
Screw out screw 4.
–
Pull the knife holder 5, complete with the corner knives 2 and the
awl 1, off of the knife bar.
–
For safe working, clamp the knife holder 5 in a vise.
–
Loosen clamping screw 3.
The clamping collar in the knife holder 5 is released.
–
Remove awl 1 and both corner knives 2.
–
Insert new corner knives in the slits of the knife holder 5.
Attention!
The angle-ground blades must show to the outside.
–
Insert the awl 1 into the appropriate drilled hole.
–
Push both corner knives into the knife holder 5 up to the stop.
Thereby bring the corner knives to the back until they touch the
awl 1.
–
Tighten clamping screw 3.
–
Push the knife holder 5 onto the knife bar up to the stop.
–
Tighten screw 4.
4 5
1
2
3