Duerkopp Adler 745-22 Service Instructions Manual page 45

1 2
3 4 5
3 4 8 9
–
Turn the handwheel until the swing lever 9 has reached its furthest
swing to the back (in the direction of the arrow).
–
Turn the swing lever 9 on the shaft 11 so that the shoulder 10 of
the latch is still just pushed off of the stopper 1.
–
Tighten clamping screw 13.
–
Attach all removed parts (head cover, cylinder with swing lever for
the thread puller) again.
Position of the needle bars to the center knife:
–
The needle bars must move counter to the center knife. With the
needles lying low the drive lever 12 must be in its upper dead
center.
–
It is essential to make a precise setting as per Chapter 11.12.
10
11
12
13
1
9
6
7
45