Cloth Slider Plate And Support Plate - Duerkopp Adler 745-22 Service Instructions Manual

8. Setting the Cloth Slider Plate and Support Plate
1
2
4
5
6
34
The cloth slider plate 1 is to be so aligned that its cutout has the same
clearance to both sides of the needle plate elevation.
The support plate 6 must be at one level with the base plate of the
machine head.
ATTENTION !
Turn the main switch off.
For safety reasons the cloth slider plate 1 is only unlocked in the
transport carriage end position and with the main switch turned off.
–
Remove the cloth slider plate 1 (see Operating Instructions).
–
Loosen screws 3 slightly.
–
Set the cloth slider plate 1 forward by sliding the holder plate 2.
–
Tighten screws 3 again.
–
Loosen the screws to be found under plate 4.
–
Set the cloth slider plate 1 at the rear by sliding the plate 4.
–
Tighten the screws under plate 4 again.
–
Set the support plate 6 at one level with the table top by turning the
setting screws 5 and 7.
3
7
7