Led; Buzzer - Epson LX-300 Service Manual

LX-300+
Operation in default setting mode
The following switches are used in default setting mode;
Table 1-19. Operation at Power On
Switch Function
Tear Off Changes the setting.
LF/FF Selects the Menu.
The others Not available.

1.4.1.2 LED

Indication in normal mode
Table 1-20. Indication in normal mode
LED
Pause *1
Printer Status
Pause On
Paper out error On
Release lever error On
Paper eject warning On
Micro Adjust Blink
Tear off ---
Font selection ---
Fatal error Blink
*1 Pause (Orange)
-It is on when the printer is paused, and it is off when the printer is not
paused.
-It blinks when Micro Adjust is enabled.
*2 Paper Out (Red)
-It is on when the printer is in the Paper out status, and it is off when the
printer is out of this status.
Product Description
Paper
Font
*2
Out
--- ---
On ---
--- ---
Blink ---
--- ---
--- *3
--- *3
Blink Blink
*3 Font (Green)
-The status of Font selection is displayed by 2 Font LEDs when continuous
paper is out of the Tear-off position.
-Both LEDs blink when continuous paper is in the Tear-off position.
: Draft
: Draft Condensed
: Roman
: Roman Condensed
: Sans serif
: Sans serif Condensed
: Tear Off
( : LED On, : LED Off,

1.4.1.3 Buzzer

Paper out error:
Release lever operation:
Illegal panel operation:
*The description (.) and (-) in the above shows how the beeper sounds.
(.): Beeper sounds approx. 100ms and interval is approx. 100ms.
(-): Beeper sounds approx. 500ms and interval is approx. 100ms.
Operation
Revision A
: LED Blinks)
Beeper sounds (...)*
Beeper sounds(-----)*
Beeper sounds (.)*
25