Removal Of Home-Position Sensor - Epson L-1000 Technical Manual

REV.-A
Remove the belt tension spring from the carriage motor frame. Remove the E-type (3.2) retaining ring on
4.
the carriage motor side, then remove the plain washer, belt pulley flange, belt pulley shaft holder, belt pulley,
and timing belt.
Move the carriage motor in the direction shown by the arrow to remove it.
5.
Assembly Point
Attach the E-rings as follows:
Using the tweezers, confirm that the attached retaining rings do not move.

4.2.5.7 Removal of Home-Position Sensor

Perform steps 1 to 3 of Section 4.2.5.6 to remove the carriage motor frame.
1.
2. Push in the notch of the home-position sensor, and remove the home-position sensor from the carriage
motor frame.
LQ-500/ L-1000
Figure 4-27. Removal of Carriage Motor
Figure 4-28. Removal of Home-Position Sensor
DISASSEMBLY, ASSEMBLY, AND ADJUSTMENT
4-19