Dip Switches And Jumper Setting; Dip Switch Settings; Table 1-11. International Character Set Selection - Epson L-1000 Technical Manual

GENERAL DESCRIPTION

1.4 DIP SWITCHES AND JUMPER SETTING

This section describes the DIP switch selections and the jumper setting for the LQ-500/L-1000 printer.

1.4.1 DIP Switch Settings

The DIP
two switches for the printer are located inside the ROM cartridge
in Tables 1-9 through 1-13. (Note that the status of the DIP switches is read only at power on or upon receipt
of the INIT signal.)
* Unidirectional printing is selected by default, however input of ESC U O can be used to set the print direction to
Bidirectional.
1-14
Table 1-9. Settings for DIP Switch 1 (SW1)

Table 1-11. International Character Set Selection

slot cover and function as shown
LQ-500/ L-1000
REV.-A