Cutting Position - DURKOPP ADLER 867 Service Instructions Manual

2.14.4

Cutting position

46
6
8
7
4
5
Caution: Danger of injury !
Turn off the main switch.
Check and set the cutting position only when the machine is switched
off.
Standard checking
With the factory setting the cutting position corresponds to the position
"thread lever in its upper dead center" (60°on the handwheel).
–
Turn the handwheel until the thread-pulling knife 1 can be swung
out.
–
Swing out the thread-pulling knife 1 manually.
In order to do so push the lever 6 with the roller 7 to the right
against the control cam 4.
–
Insert the thread into the thread-pulling knife 1.
–
Turn the handwheel until the thread is cut.
–
Check whether the cutting took place in the position "thread lever
in its upper dead center" (60°on the handwheel).
3
9